Page 28 of 48
Air Handling Systems Catalog Home Page
Previous | Next
Air Handling Systems’ TEES (continued)

Tees

Lateral Tees

To minimize turbulence and possible particulate that may settle out in your dust and fume collection ductwork, we recommend that Lateral Tee branches enter the main at a 45° angle.Lateral Tees should be installed to the side of the main, and no two branches should be entering opposite one another.

Material Specification & Installation

Our Lateral fittings are fabricated out of 20 gauge galvanized metal, with all seams welded solid to make an airtight system. To allow for an easy installation, tees are fabricated with a bead 2 inches in from each small end. This allows Air Handling Systems Spiral Pipe or Flexhose to fit over the Tee and set up tight against the bead. For a permanent installation, it is recommended that you place a small amount of silicone about one inch in and around the inside of the Spiral Pipe before you assemble any fitting. This chemical bond will make your Air Handling System completely airtight.

AHS ON THE JOB - John Chudy, Chudy Air Systems - Palmer, MA

"Ductwork and fittings were easy to install. Custom hoods andfittings are readily available when needed."

90° Bullhead Tee

Bullhead Tees are best used in low pressure heating and air conditioning systems.
Same as LT Price, see chart. When ordering, simply replace LT with BT.

90° Boot Tee

Boot Tees are commonly used in confined area that does not allow use of 45° Lateral Tee.
Same as LT Price, see chart. When ordering, simply replace LT with BOOT. Example: 06BOOT12
Other sizes available upon request.
Shop Online www.airhand.com

Air Handling Systems - Home Page

If your are interested in ordering any of our products, the process is simple. Just click on Shop Online and select the product(s) you want to buy. It's as easy as that!!!

Should you have any questions, we offer a Frequently Asked Questions section that answers the many questions submitted to us over the years.

If you are interested in obtaining a copy of our guide to designing a system, click on Airhand Designing a System and you can either have us mail it to you or you can download your own copy.

One of our special features is the ability to manufacture custom tees. To find out more information, click on Manufacturing (Custom Parts)

We welcome your questions and comments. If you want to contact us, your can either send us an email at sales@airhand.com or phone us at either: 800.367.3828 or 203.389.9595.
Our fax number is:
800.438.7135 or 203.389.8340

Our company has over 50 years of expertise with a deep commitment of customer service. We are the single source for all your dust & fume collection and industrial ventilation components. You can rely on Air Handling Systems for cost-effective, high quality components. Our technical sales staff is ready to help solve your problems.

CONTENTS

Access Doors30 Angle Rings19 Ball Joints34 Bellmouths34 Blastgates32 Couplings18 Design Information10-13 Duct Silencers33 Easy Connect System18 Elbows22 End Caps / End Plugs18 Extension Arms39 Flexhose40-47 Floorsweeps34 Hangers20-21 Installation Information14 Nozzles35 Offsets27 Radial Saw Hoods34 Reducers31 Spiral Pipe16-17 Stainless Pipe37 Tees27-29 Y Branches29 Transitions35 Up-Blast Stack Caps36
Previous | Next
Air Handling Systems Catalog Home Page
Page 28 of 48
Dust Collection | Ventilation Systems | Dust Control | HVAC Systems & HVAC Ducts | Ducting | Ductwork | Custom Manifold
Industrial Ventilation | HVAC System Ducting | Spray Booth Fume Control